FuguIta-6.3-arm64 for Raspberry Pi 3 (test version)

FuguIta-6.3-arm64 is a live system based on OpenBSD 6.3/arm64.
It can be run on Raspberry Pi 3.

This is shipped with network pre-configured,
so you can install and use this sytem without serial cable.

Install:

* Download miniroot63-fi-rasp3b.fs and FuguIta-6.3-arm64-201805301.img.gz
  from FuguIta's download site.
* Write miniroot63-fi-rasp3b.fs to a SD card.
* Unzip and write FuguIta-6.3-arm64-201805301.img.gz to a USB flash drive.
* Attach the SD and the USB to Raspberry Pi 3, then boot.
* On FuguIta-6.3-arm64, networking is pre-configured.
   IP addr.: 192.168.1.147
   SSH port: 4272


Login:

* After boot started, about 75sec it replies for PING,
  and about 110sec SSH becomes available.
* Console device is still serial port.
  You can login via both serial and network.
  (username = fuguita, password = fugu.ita)
* After the first login, changing fuguita's password
  is highly recommended.


Change Settings:

* To change default settings of FuguIta-6.3-arm64,
  for example, you may edit files listed below
  on your needs.

  ---------------------+--------------------
  Setting              | File
  ---------------------+--------------------
  time zone            | /etc/localtime
  host name            | /etc/myname
  default gateway      | /etc/mygate
  IP address / netmask | /etc/hostname.smsc0
  host name database   | /etc/hosts
  name server          | /etc/resolv.conf
  ---------------------+--------------------

  For more details, see the manual page for
  each command.

* After all settings changed, you should perform
  'usbfadm -r' command to make them persistent.
  When this command ran, all those settings
  will be loaded at next boot.


Notes:

* Almost same as FuguIta i386/amd64, but 'newdrive' of usbfadm utility
  will not work properly. 'target', 'saveas' and 'sync' are OK.
* sd0d:/noasks is the file which holds FuguIta's auto-boot configurations.
* At boot time, sd0d:/livecd-config/6.2/arm64/fuguita.default is
  copied into tmpfs (/ram).
* sd0d:/livecd-config/6.2/arm64/fuguita.templ holds the factory defaults.
  You can recover by overwriting fuguita.templ directory to fuguita.default.

Have fun!

Yoshihiro KAWAMATA